Air Cooler ( Dessert Cooler ) Maintenance

 the maintenance is necessary of all electrical equipment , efficiency improvement due to maintenance.

today we discuss about air cooler known also as a desert cooler.

Main parts of Air cooler 

1. Exught Fan 2. Water pump( tullu pump) 3. cooling Pad 4. Body 5. Switch and regulator 6. safety grill.

Explanations each part-

1. Exught fan-when sesion is off than paint the fan body and fan legs. and do proper bearing lubrication,also check fan tightness and ballance.

2. Water pump - water pump not  run empty if pump run empty can burn pump.

if pump is not runnig so open rotor and clean.this pump is use and through not repairable, check water discharge pipe is clean and proper water distribute all side.

3. cooling pad - There is another important part that you can’t ignore in your air cooler – the cooling pads. Ideally, you should change it every season.They feature honeycomb pads that provide maximum performance with minimum maintenance. All you need to do is clean them and check if they are seated properly. Once done, turn on the water supply to find out if water is running through the entire cooler pad or not. Too little water will cause dry spots and reduce the cooler’s efficiency.

4. Body- Air cooler body is two type 1. iron or GI 2. Fiber

mostly  iron cooler is outdoor and fiber is indoor, if body is iron or GI so we need every seaison paint and fiber no need paint. do not put any object on cooler body.

5. Switch and regulator- check connection of switch and regulator if not work proper so we need to replace.

6. Safety grill - safety grill is front of cooler , this avoid finger and any part cut by fan.

Thanks.

Om prakash bishnoi